Message archiver11/10/2023 In the add smart host page, enter the Barracuda Message Archiver fully qualified domain name (FQDN) or IP address: In the Network settings page, select Route mail through smart hosts : In the Name field, enter a name for the connector, and in the Type section, select Custom:.Log into the EAC, click mail flow in the left pane, select send connectors at the top of the page, and then click the + symbol to create a new send connector:.To route journaled mail that is sent to the contact to the Barracuda Message Archiver, use the following steps to create a Send Connector for the Remote Domain: To ensure proper mail flow, verify that the Barracuda Message Archiver send connector has a lower cost value than the send connector for outbound SMTP traffic. External email address – Type Click save.Display name – This field automatically populates.In the new mail contact dialog box, enter the following details:.Click the + symbol, and click Mail contact:.Log into the Exchange Admin Center (EAC), and click recipients > contacts.Use the following steps to create the Mail Contact: Create a Remote Domain From the Exchange Management PowerShell. ![]() The email address associated with this account is the designated recipient and must be associated with a non-existent, non-routable dummy Domain Name created above in Step 2. The Mail Contact is the account that is to act as a "holding location" for journaled messages. Create a Recipient Mail Contact/Alternate Email Address Get-RemoteDomain | Where |Format-table Name, DomainName, TNEFEnabled, AutoForwardEnabled
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |